Maintenance Procedures (M - Honda HRM4000EC Owner's Manual

Maintenance procedures
Preparing
• Put on a pair of work gloves.
• When checking the blades, turn the lawnmower on its side.
Cleaning
N WARNING
- Do not touch the blades with your hands.
- Do not lift the lawnmower off of the ground while checking or cleaning it.
- Make sure to press the manual STOP button and press the B (Off) button to turn the power off
before performing the following procedures.
You can wash the lawnmower using a car washing hose or garden hose.
N CAUTION
- Never use an industrial high-pressure washer, household high-pressure car washer, a solvent or
a scraper (iron, resin).
- Never spray the docking station with water (from a car washing hose or garden hose).
Cleaning the body (Exterior)
Clean dirt and grass off of the lawnmower using a plastic
brush and cloth.
Removing the grass clippings
To remove the grass clippings from the underside of the lawnmower.
Set the cutting height to 20 mm (M page 61). Raise the front of the lawnmower and lean it against a wall (at
about 90°). Make sure that is no damage (tears, scratches, etc) to the motor housing boots, and then spray
the underside with water. You may also use a plastic brush and cloth.
N CAUTION
- Never use a scraper. The scraper may cause damage to the rubber boots on the underside of the
lawnmower.
- Do not clean (spray wash) using any detergents or waxes, including mild detergents and
automotive cleaners.
Rear (drive) wheels
92
Front (caster) wheels
Blades and
blades disc
Top and sides
Charging socket
Motor housing boots
Control panel
Scraper