Table of Contents
Advertisement
6
USAGE
Checking the mowing area
Before operating the lawnmower, ensure the mowing area is free of
animals and foreign objects.
Turn off the lawnmower before removing any foreign objects.
NOTE:
- If there are any holes (such as rabbit holes, etc.) in the work area,
fill them in so that the work area is level. Periodically check the
work area for holes.
Also confirm that the height of the grass is 65 mm or less.
NOTE:
- Adjust the height of the blades to mow the grass within 5 mm.
If the grass is taller than 65 mm, cut the grass using a standard
lawnmower. For details on how to adjust the height of the blades,
see "Cutting height" (M page 60).
Connecting to a power source
Follow the steps below when connecting to a power source.
Follow these steps in reverse when disconnecting from a power source.
For details on moving the AC adapter or changing to a different power outlet, contact your dealer.
NOTE:
- Connect the station only to a supply circuit protected by a residual current device (RCD) with a tripping
current of not more than 30 mA.
Remove the station cover from the docking station.
1
If the power cord of the AC adapter is not long enough, connect the
2
extension cord.
NOTE:
- When disconnecting the connectors, make sure to lift the clip.
- When the length of the cord is not enough even if you use an
extension cord, extend the power outlet (House) side.
Connect the power cord connector to the station's internal
3
connector.
Pass the power cord through the tabs as shown.
NOTE:
- When disconnecting the connectors, make sure to lift the clip.
Checking the mowing area / Connecting to a power source
65 mm or less
Power outlet (House) side
77
Advertisement
Table of Contents
