Overview; How The Honda Robotic Lawnmower Works; Features - Honda HRM 520 Owner's Manual

How the Honda Robotic Lawnmower works / Features
1

OVERVIEW

How the Honda Robotic Lawnmower works

Configuring the system
The mowing area is determined by the boundary wire that emits a signal; when the
lawnmower detects the boundary it turns and it cuts the grass randomly. When battery
starts running out, it goes back to the docking station.
Pegs
Boundary wire
Lay the boundary wire by securing it on the ground
with pegs, or burying it under the ground.

Features

Mowing start points
You can designate the start points from which the Honda
Robotic Lawnmower will start mowing. Mowing start
points allow your lawnmower to reach other areas which
are difficult to access. Some mowing start points can be
set by laying a boundary wire, increasing efficiency.
NOTE:
- You can configure the following start points for
each model:
HRM310: 3 start points
HRM520: 5 start points
4
Transformer
The transformer must be installed in a shaded area
protected from rain.
Docking station
More
than
1 m
More
than
2 m
Power cord
Robotic Lawnmower
Operation timer
The Honda Robotic
Lawnmower has multiple
settings for designating the
day and time the lawnmower
operates. You can configure
the lawnmower to run on
your days off, or during
certain times that are
convenient for you.
Install the docking station with
appropriate boundary wire length.
In the case of this figure, there
must be more than 2 m from the
front of the docking station and
more than 1 m from the rear of
the docking station. For details,
see "Checking conditions for
installation" (M page 12).
Convenience
After configuring the Honda
Robotic Lawnmower, it starts
and stops mowing without any
prompting. When the timed
programme is complete or the
battery's charge becomes low,
the lawnmower automatically
returns to its docking station and
recharges its internal battery.