Rear Panel - Electrolux 6 Series Service Manual

6.14 Rear panel

 Remove the worktop.
 Remove the sides.
 Using a pair of pliers open the clamp and
disconnect the red pipe from the connector.
 Pull out the red pipe so it is free from the
rear panel.
 Loosen the screws securing the tank fitting
and remove it.
 Disconnect the power supply cable from the
main board.
 Disconnect all the mass connections on the
back panel.
ATTENZIONE
Warning to remove the
connectors slightly lower
the locking lever indicated
in the figure.
 Remove the rear air conduit.
 Loosen the 2 screws securing the rear panel
to the appliance base.
 Loosen the 4 screws securing the rear panel
to the side crossbars and the screw securing
it to the central crossbar.
 Release the clip on the tank support.
 Tilt and remove the back panel.
Technical Support - A.D.L. 41/66 599 74 32-54 Rev.01