Electrolux 6 Series Service Manual page 55

Ex97 Missing programme on CTF alarm
Ex98 Inconsistent inverter board protocol
Ex9C User interface checksum alarm
One or more touch keys on the user
Ex9E
interface does not work
ExH1 Power supply frequency out of range
Power supply voltage out of range
ExH2
(too HIGH)
Power supply voltage out of range
ExH3
(too LOW)
ExH4 Zero Watt relay alarm
ExHD Current leakage alarm
ExHE Safety line alarm
ExHF Safety line sensing alarm
Technical Support - A.D.L.
Full name
 Only detected when configuration is performed.
 Does not allow the cycle to start.
 Only detected when configuration is performed.
 Does not allow the cycle to start.
 No action possible.
 No action possible.
 If detected in setup, it would not be possible
cycle starting. If happens during cycle execution,
it suspend working.
 It is automatically cleared when power supply
return within right limits, it would be possible to
start. If a cycle was temporary suspended due
to this alarm it automatically restarts.
 The tumble dryer is working properly but the zero
Watt circuit is never activated.
 The cycle is suspended.
 The cycle is suspended.
 The cycle is suspended.
Action
55/66
Notes and possible causes
 Wrong selector configuration (MCF) or missing
cycle on cycle table (CCF).
 The user interface board is not compatible
with the main board.
 Inverter board faulty.
 Bad main board configuration.
 Faulty wiring.
 Presence of damp on the user interface board.
 Board faulty.
 Power supply problems.
 Wrong MCF.
 Main board error.
 Power supply problems - TOO HIGH VOLTAGE.
 Wrong MCF.
 Main board error.
 Power supply problems - TOO LOW VOLTAGE.
 Wrong MCF.
 Main board error.
 Main board faulty.
 Current leakage of any actuator.
 Faulty wiring.
 Main board faulty.
 Main board faulty.
 Main board faulty.
599 74 32-54 Rev.01