6.6 Main electronic circuit board
Remove the worktop.
Remove the right side panel.
Unhook the board protection fitting clips
and remove them by pulling them upwards.
Disconnect all connectors, making a note of
their positions.
Remove the two fastening screws from the
crossbar.
Move the entire board assembly towards the
control panel so as to unhook and remove it.
6.7 Panel de control
Remove the worktop.
Remove the tank.
Loosen the three screws securing the control
panel to the uprights and air conduit.
Loosen the 2 screws that secure the control
panel to the tank support.
Rotate it forwards.
Remove the wiring, making a note of the
position of the various connectors.
Remove the entire control panel.
Technical Support - A.D.L.
30/66
599 74 32-54 Rev.01