6.17 Frontal piece
Remove the worktop.
Remove the control panel (you do not need
to disconnect it electrically).
Loosen the 2 screws securing the appliance
door to the air conduit.
If present, remove the aesthetic cover above
the door block (not shown in the figure) using
a screwdriver.
Loosen the 3 screws securing the front panel
to the air conduit.
Loosen the 2 screws on either side securing
the front panel to the air conduit.
Tilt the front panel slightly forward and lift it.
6.18 Drum light
Remove the frontal piece.
Disconnect the connector.
Slightly press the two clips that hold the drum
lamp and simultaneously push it inwards until
it is completely removed.
Technical Support - A.D.L.
43/66
599 74 32-54 Rev.01