Canister Container (Models With Canister In Upper Section); Removal Of The Cover And Rear Panel Gives Access To; Heater Unit - Electrolux EDR1000NEW Service Manual

13.2.7 Canister container (models with canister in upper section)

a. Remove the screws which secure the canister container to the control panel and to the rear panel.
b. Detach all the anchor tabs which secure it to the control panel support.

13.3 Removal of the cover and rear panel gives access to:

13.3.1 Heater unit

a. Remove the screws (1) which secure the plastic rear panel cover (in the centre of the panel) and release the
anchor tabs (2) from around the external perimeter.
b. Remove all the perimetral screws which secure the central cover to the rear panel.
c. Remove the side panel (viewing the appliance from the front).
d. Remove the screw which secures the side panel to the cross-member (after removing the canister).
When replacing the side panel, replace the screws in their original positions, otherwise the continuity of the earth
circuit will be broken.
e. Remove the screws which secure the side panel to the rear panel, lift and remove.
The terminal block for the heater unit is located inside the microswitch support, and secured in position by an
anchor tab.
f. Insert a screwdriver, release the anchor tab and remove the terminal block. Remove the wire ties that secure
the wiring to the base and remove the wiring.
g. Remove the two screws which secure the heater unit to the rear panel. N.B. The right-hand screw of the
heater unit also secures a deflector.
Before replacing the heater unit, be sure to re-position the wiring in its original position.
SOI/DT 2003-12 dmm
a
e
40/50
b
f
d
g
599 36 20-08