Rear Air Seal; Anti-Entanglement Cone - Electrolux 6 Series Service Manual

6.15 Rear air seal

 Remove the rear panel.
 Raise the air seal to remove it completely.
ATTENZIONE
When repositioning the front air seal, make sure
the joint is approximately positioned as shown in
the figure.

6.16 Anti-entanglement cone

The anti-entanglement cone ensures that during
the drying stage the washing does not get tangled
up in itself.
 Press the blocking pin to remove and rotate
the cone anti-clockwise.
 Loosen the three fastening screws to also
remove the base.
 Insert the cone in its slot to re-assemble it and
rotate it clockwise until you hear a click that
indicates the correct insertion of the blocking pin.
Technical Support - A.D.L. 42/66 599 74 32-54 Rev.01