Electrolux 6 Series Service Manual page 26

Position 10
Last alarm display and possible
reset
Position 11 and subsequent positions
Last alarm display and possible
reset
Technical Support - A.D.L.
Purpose of the test:
Behaviour:
Working conditions:
Behaviour:
Working conditions:
26/66
To see the alarm and delete it.
The LCD display flashes and shows any alarm
present.
Turn the dial to position 10, paying attention not
to stop in position 8 in order to avoid error 32.
Press the START / PAUSE button to see all the
alarms present.
To delete the alarms, hold down the START /
PAUSE buttons and press the button on the left.
All LEDs flash in sequence.
Press a button and the corresponding LED is lit;
the code is shown on the LCD display and the
buzzer sounds.
Door closed (time out 10 secs.).
599 74 32-54 Rev.01