Mitsubishi Electric 800 Series Instruction Manual page 36

NOTE
• When a communication line error has occurred, reset cannot be made from the network.
• The inverter is set to the External operation mode if it has been reset in Network operation mode in the initial status. To
resume the network operation, the inverter must be switched to the Network operation mode again. Set a value other than
"0" in Pr.340 to start in the Network operation mode. (Refer to
• Communication continues during inverter reset. (The inverter cannot be controlled for about 1 second after release of a
reset command.)
Error reset operation selection at inverter fault
An error reset command from communication option can be invalid in the External operation mode or PU operation mode.
An error reset command from the network is requested by STW (bit 7) (PPO type 1 to 5). (Refer to
Pr. Name
Communication reset selection/Ready bit
status selection/Reset selection after
349
inverter faults are cleared/DriveControl
writing restriction selection
*1 The same operation is performed regardless of the setting value.
page 25.)
Initial Setting
value range
0, 100, 1000,
1100, 10000,
Error reset is enabled independently of operation mode.
10100, 11000,
*1
11100
0
1, 101, 1001,
1101, 10001,
Error reset is enabled only in the network operation mode.
10101, 11001,
*1
11101
page 54.)
Function
INVERTER SETTING
4
35