Mitsubishi Electric 800 Series Instruction Manual page 15

Hide thumbs Also See for 800 Series:

Table of Contents

Installing the option

Insert two spacers into the mounting holes that will not be filled with mounting screws

Fit the board mounted option connector on this product to the guide of the option connector on the inverter and insert the

option as far as it goes. (Select option connector 1 on the inverter.)

Fasten the earth plate to the inverter using the one mounting screw through the hole on the left side

torque 0.33 N∙m to 0.40 N∙m).

Fasten this product to the inverter using the one mounting screw through the hole on the left side. Fasten the earth plate

and this product to the inverter using the last screw through the hole on the right side of the earth plate and this product

(tightening torque 0.33 N∙m to 0.40 N∙m). If the screw holes do not line up, the connector may not be inserted deep

enough. Check the connector.

INSTALLATION

(page

16).

(page

16) (tightening

Table of Contents

Fr-a8np