Danfoss ICM User Manual page 3

ICM and ICMTS Motorized Valves with ICAD Actuators
Status/Next Service
Status/Supply
Status/Read Outs Parameters
Alarms/Alarm Parameters
Alarms/Event Log Parameters
Info
Non-displayed Parameters
Troubleshooting
Overview
Warnings and Alarms
Troubleshooting Tips
The valve does not appear to close or stay closed completely
The valve does not appear to be moving to the correct position
The valve does not appear to be opening fast enough or seems too fast
The valve position feedback signal is not working with the customer supplied
controller/PLC
Frequently Asked Questions
What happens in the event of a power failure?
How much power do I need to supply to the ICAD?
How can I monitor the valve position remotely?
At what minimum OD%/mA will the ICAD automatically close and calibrate?
If the 4-20 mA signal is lost while the valve is open, will the ICAD close the valve?
How many turns/revolutions with the manual tool will fully open/close ICM valve?
Does the ICAD make a high frequency noise?
What size wire gauge is recommended to run to the ICADs?
When running wire to the ICADs, does the wire need to be shielded?
Online support
© Danfoss | Climate Solutions | 2024.01 BC465027827472en-000102 | 3
28
28
29
31
33
35
36
38
38
38
39
39
39
40
40
41
41
41
41
41
41
41
42
42
42
43