Dual Host Configuration - Accusys ACS-8910 User Manual

4.1.5 Dual Host Configuration

Note: This Section is only performed when the daughter board is connected to the ACS-8910
controller.
1. Turn on the ACS-8910 from power supply switch.
2. Press the [ENT] button to display the "Main Menu" menu.
3. Press the [ENT] button to open the "1 RAID Params" menu.
4. Repeatedly press the [▼] button until the "11 Re-conf
RAID" menu is displayed, then press [ENT] button.
5. Repeatedly press the [▼] button until the "12 RAID Level"
menu is displayed, then press the [ENT] button.
6. Select the listed "0, 1,3,0+1,5" to configure a RAID Level,
then press the [ENT] button.
7. Repeatedly press the [▼] button until the "13 Disk Number"
menu is displayed, then press the [ENT] button.
8. Press the [▼] button to select the number of the disks to
configure the ACS-8910, then press the [ENT] button.
NOTE: The disk number does not include "hot spare".
9. Press the [ESC] button to display the "Main Menu" menu.
10. Repeatedly press the [▼] button until the "21 Primary
SCSI" menu is displayed, then press the [ENT] button.
11. Repeatedly press the [▼] button until the "211 Set SCSI ID"
menu is displayed, then press the [ENT] button.
12. Press the [▼] button to select a SCSI ID for ACS-8910, then
press the [ENT] button.
NOTE: The default setting is SCSI ID 0.
35