10-Pin To 9-Pin D-Sub Male Interface Cable - Accusys ACS-8910 User Manual

3.5.3 10-pin to 9-pin D-sub male Interface Cable

The ACS-8910 controller can be configured via PC running a VT-100 or ANSI terminal-emulation. In
order to connect to PC, you need to connect an additional interface cable to the extension cable, which
converts the RS-232 signal of the 10-pin header connector into a 9-pin D-sub male connector. The
pin-layout of the 9-pin D-sub male connector is similar to that of PC's serial power and is set as a DTE
device.
Refer to Chapter 5 for more information on configuring the ACS-8910 through a VT-100/ANSI terminal
session.
10-pin to 9-pin D-sub male Interface Cable
10-pin header
9-pin male D-sub header
GUIDELINES:
The serial port's default is set at 19200 baud, 8 bit, 1
stop bit, and no parity. Use the COM1 serial port of the
controller. The baud rate can be changed using the
interface on front panel.
When using PC as a terminal, any VT-100 compatible
terminal software will work.
24