Accusys ACS-8910 User Manual page 36

13. Repeatedly press the [▼] button until the "212 Termination"
menu is displayed, then press the [ENT] button.
14. Press the [ ▼ ] button to enable or disable the SCSI
termination for ACS-8910, then press the [ENT] button.
NOTE: If the ACS-8910 is the only SCSI device on the
bus or is at the end of a daisy chain the termination
should be enabled. If the ACS-8910 is in the middle of a
daisy chain the termination should be disabled.
15. Repeatedly press the [ ▼ ] button until the "213 Tag
Queuing" menu is displayed, then press the [ENT] button.
16. Press [▼] button to enable or disable the Tag Queuing for
ACS-8910, then press the [ENT] button.
NOTE: The default setting for Tag Queuing is "Enabled".
Tag Queuing allows the ACS-8910 to process multiple
requests thus improving performance.
17. Press the [▼] button to select the "214 Ultra " and " 215
Wide" menu.
18. Follow the list below to setup SCSI interface of Host
Speed/Wide
SCSI Interface
SCSI-2
Wide SCSI
Ultra SCSI
Ultra Wide SCSI
Ultra 2 SCSI
19. Press the [ESC] button and the [▼] button until the "22
Secondary Host" menu is displayed, then press the [ENT]
button.
Wide Fast Ultra
[ENT]
Disable
Enable [ENT]
[ENT]
Disable
[ENT]
Enable
Enable
36
Ultra2 Ultra 3
[ENT]