Accusys ACS-8910 User Manual page 28

14. Press the [▼] buttons to enable or disable the SCSI termination
for the ACS-8910, then press the [ENT] button.
NOTE: If the ACS-8910 is the only SCSI device on the bus or
is at the end of a daisy chain, the termination should be enabled.
If the ACS-8910 is in the middle of a daisy chain the termination
should be disabled.
15. Repeatedly press the [▼] button until the "23 Tag Queuing" menu
is displayed, then press the [ENT] button.
16. Press the [▼] button to enable or disable the Tag Queuing for the
ACS-8910, then press the [ENT] button.
NOTE: The default setting for Tag Queuing is "Enabled".
Tag Queuing allows the ACS-8910 to process multiple requests
in order to improve the performance.
17. Press the [▼] button to select the "24 Speed" and " 25 Wide" menu.
18. Follow the list below to setup SCSI interface of Host.
Speed/Wide
SCSI Interface
SCSI-2
Wide SCSI
Ultra SCSI
Ultra Wide SCSI
Ultra 2 SCSI
19. Press the [ESC] button to return to the "Main Menu" menu.
20. Repeatedly press the [▼] button until the "5 NVRAM" menu is
displayed, then press the [ENT] button.
21. Repeatedly press the [▼] button until the "51 Update NVRAM"
menu is displayed, then press the [ENT] button.
Wide Fast Ultra
[ENT]
Disable
[ENT]
Enable
[ENT]
Disable
[ENT]
Enable
Enable
28
Ultra2 Ultra 3
[ENT]