Accusys ACS-8910 User Manual page 72

IDE_ISR: wait IDE interface is waiting for an interrupt from a disk.
Master Int
IDE_ISR: wait IDE interface is waiting for disk to be free.
IDE Busy off
IDE_ISR: status ? IDE disk drive current status (?)
IDE_ISR: wait To wait for disk drive to turn off DRQ in Interrupt phase.
DRQ
IDE_ISR: DRQ Indicates DRQ is not free in Interrupt phase.
ON
DISK: status ?, The status (status ?) and error (error: ?) returned by the disk
error: ? !! based on the ATA-2 Specification.
DISK: #X type=?, The disk (x) failed to respond to a request by the controller
blkno=?, resid=? (type=?).
failed. The remaining sectors (resid=?)
DISK: Initialize #? The disk (x) was unable to be initialized by the controller.
ERROR! Possible bad disk.
DISK: #x is Disk number (x) failed and was removed from the RAID
off-line! configuration.
DISK: #x not The disk (x) is not detected by the controller. Possible bad
installed! disk.
DISK: #x ERROR The disk (x) caused an error. The status (?) returned by the
status ? ! disk per ATA-2 Specification.
ERROR: Not a The controller does not recognize the device installed.
hard disk!
ERROR: Disk The controller was unable to read the disks parameters
parameters (Cylinder, Heads, Sectors, Multi-Sector). Possible bad disk.
ERROR!
Error Message Explanation
ERROR: No The disk does not support the ATA-2 multi-sector transfer
multi-sector function. The disk is an older IDE disk.
mode!
ERROR: IORDY Disk does not support IORDY. Possible older IDE disk that
not support! does not support ATA-2 Specification. Must replace disk.
DISK: #? Remap The area used to re-map bad sectors is full.
area overflow !
DISK: #? Blk Block number (?) is detected as a bad sector and has been
no: ? is remapped. re-mapped.
DISK: #? Remap No re-map sectors are available while the controller detected
area is empty! bad sectors.
Modem time-out! The modem did not respond to the page or FAX notification
request. Modem may be turned off or not connected.
All modem User stopped the modem from sending a page or FAX
operations are notification.
canceled!
Training FAIL! Fax Class 1 support -- modem fails in training phase.
Page transfers The page notification failed. Modem may be turned off or not
FAIL! connected.
FAX: Modem is The modem is currently is use and unable to send a FAX
busy! notification.
Paging: Modem is The modem is currently is use and unable to send a page
busy! notification.
Invalid NVRAM The information stored in the NVRAM area is invalid and
The block number (blkno=?) where the request
72