Single Host Configuration - Accusys ACS-8910 User Manual

4.1.2 Single Host Configuration

1. Turn on the ACS-8910 from power supply switch.
2. Press the [ENT] button to display the "Main Menu" menu.
3. Press the [ENT] button to open the "1 RAID Params" menu.
4. Repeatedly press the [▼] button until the "11 Re-conf RAID"
menu is displayed then press the [ENT] button.
5. Repeatedly press the [▼] button until the "12 RAID Level" menu
is displayed then press the [ENT] button.
6. Select the listed "0, 1,5" to configure a RAID Level, then press the
[ENT] button.
7. Repeatedly press the [▼] button until the "13 Disk Number" menu
is displayed, then press the [ENT] button.
8. Press the [▼] buttons to select the number of disks to configure
for the ACS-8910, then press the [ENT] button.
NOTE: This disk number does not include "hot spare" disk.
9. Press the [ESC] button to return to the "Main Menu" menu.
10. Repeatedly press the [▼] button until the "2 SCSI Params" menu
is displayed, then press the [ENT] button.
11. Repeatedly press the [▼] button until the "21 Set SCSI ID" menu
is displayed, then press the [ENT] button.
12. Press the [▼] button to select a SCSI ID for ACS-8910, then press
the [ENT] button.
NOTE: The default setting SCSI ID is 0.
13. Repeatedly press the [▼] button until the "22 Termination" menu
is displayed, then press the [ENT] button.
27