Special Warnings And Information; Equipment Used In Hazardous Locations - Ametek WDG-V HP Series Manual

Special Warnings and Information

Equipment Used in Hazardous Locations

Refer to Specifications in this document for details about the suitability of this
equipment in hazardous locations. This analyzer must not be commissioned
until a person trained in the area of evaluating equipment for use in hazardous
classified locations has confirmed that this equipment and its installation are in
compliance with the requirements for the area.
10 | Thermox ® WDG-V HP Series and WDG-V/S Series Analyzers
Explosion Hazard – Substitution of Components May Impair Suitabil-
ity for Class I and Class II, Division 2, Zone 2.
Risque d'explosion – La substitution de composants peutrendre ce
materiel inacceptable pour les emplacements de Class I and Class II,
Division 2,et Zone 2.
Explosion Hazard – Do Not Disconnect Equipment Unless Power Has
Been Switched Off or the Area is Known to be Non-Hazardous.
Risque d'explosion – Avant de déconnecter l'équipement, coupez le
courant où vous assurez que l'emplacement est designé non dan-
gereux.
Warning – Explosion Hazard – Do not open when an explosive atmo-
sphere is present.
Avertissement – Risque d'explosion – Ne pas ouvrir en présence d'une
atmosphère explosive.
Warning – Do not remove or replace fuse when energized.
Avertissement – Ne pas retirer ou remplacer le fusible lorsqu'il est sous
tension.
All input and output wiring must be in accordance with wiring meth-
ods authorized for the area classification by the authority having
jurisdiction and IEC 60079-14.
PN 10686-17-5, Rev A