Furuno TZT2BB Installation Manual page 51

[Radar] menu - [Radar Initial Setup]
Menu item
[Antenna Rotation]
[Antenna Heading Align]
[Main Bang Suppression]
[Enable Sector 1 Blanking] Up to two sectors may be selected for
[Enable Sector 2 Blanking]
[Radar] menu - [Antenna Position]
Menu item
[Longitudinal (from bow)] Referring to the figure on the right,
[Lateral (-Port)]
[Antenna Height]
[Auto Tuning]
[Tuning Source]
[Manual Tuning]
[Radar Monitoring]
[Radar Optimization]
Description
Select the speed of antenna rotation. Not
available (greyed out) with the radar sensor
DRS4DL+.
See "How to align the antenna
heading" on page 3-14.
If main bang appears at the screen center,
slide the circle icon so that the main bang
disappears, while watching the radar echo
at the left-hand side of the display.
blanking (no transmission). Select [ON] to
enable this feature. Set the start and end
angles (0° to 359°).
Description
enter the radar antenna positioning
bow-stern (Longitudinal) and port-
starboard (Lateral) position from
the origin.
Select the height of the antenna above the
waterline. Not available (grayed out) with
the radar sensor DRS4DL, DRS4DL+.
Enable/disable auto tuning for the connect-
ed radar.
Not available (grayed out) with DRS2D-
NXT/DRS4D-NXT/DRS6A-NXT/DRS12A-
NXT/DRS25A-NXT.
Select a display in the dual range display to
manually tune.
Not available (grayed out) with
Select the height of the antenna above the
waterline. Not available (greyed out) with
the radar sensor DRS4DL+
/DRS2D-NXT/DRS4D-NXT/DRS6A-NXT/
DRS12A-NXT/DRS25A-NXT.
Manually tune the radar.
Not available (grayed out) with DRS2D-
NXT/DRS4D-NXT/DRS6A-NXT/DRS12A-
NXT/DRS25A-NXT.
Display various information regarding the connected radar.
Automatically adjust magnetron output and tuning for the connected ra-
dar. Available when the [TX/STBY] setting is [ON]. Do not change these
settings. Not available (grayed out) with the radar sensor DRS2D-NXT,
DRS4D-NXT. DRS6A-NXT, DRS12A-NXT, DRS25A-NXT.
Note 1: For the service technician only.
Note 2: Do this function whenever the magnetron is replaced.
3. EQUIPMENT SETUP
Options (setting range)
[Auto], [24 RPM]
[-179.9°] to [+180.0°]
[0] to [100]
[ON], [OFF]
Options (setting range)
[0] m to [999] m
[-99] m to [+99] m
Port-side is negative,
Origin Origin
Starboard-side is positive.
[Under 3m], [3m-10m],
[Over 10m]
[ON], [OFF]
[Range1], [Range2]
[-50] to [50]
3-13