Furuno TZT2BB Installation Manual page 47

[CALIBRATION] menu
Menu item
[Heading] Offset heading data.
[Speed Through Calibrate speed data. Enter amount in percentage.
Water]
[Wind Speed] Offset wind speed data. Enter amount in percentage. -50% to +50%
[Wind Angle] Offset wind angle data.
[Sea Surface Offset sea surface temperature data.
Temperature]
[DATA DAMPING] menu
Menu item
[COG & SOG]
[Heading]
[Speed Through Water]
[Wind Speed & Angle]
[Rate of Turn]
[FUSION] menu
Menu item
[Connect to Fusion]
[Fusion Auto Volume]
[Minimum Speed]
[Maximum Speed]
[Volume Increase]
[BROWSER INSTALLATION] menu
Menu item
[FAX-30 Browser]
[FA-30 Browser]
[FA-50 Browser]
[Initial Setup] menu (Other menu items)
Menu item
[Chart Master Device]
[System ID]
[IP Address]
[Synchronization Log]
[Quick Self Test]
Description
Description
Set data damping time. The lower the setting
the faster the response to change.
Description
Connects to your Fusion equipment.
Set to [ON] to allow the NavNet TZT2BB unit
to control the FUSION volume. Volume is
adjusted according to vessel speed.
Set the minimum speed threshold. Exceed-
ing this speed activates volume auto control.
Set the maximum speed threshold.
Set the amount of extra volume to output
when the vessel reaches the [Maximum
Speed] setting.
Description
Show the Facsimile Receiver FAX-30 display.
Show the AIS Receiver FA-30 display.
Show the AIS Receiver FA-50 display.
Description
Set to [ON] to use this unit as the master, [OFF] to use this unit as a slave.
(This menu does not appear on monitors connected to the HDMI OUT2
port.)
Note 1: Set to [ON] on one of the TZT2BB on the network. For two or more
TZT2BB, set to [ON] for only one unit.
Note 2: For two or more TZT2BB, do not re-set this item once it has been
set. If you set it incorrectly, get the unlock code. For information on how to
get the unlock code, refer to Troubleshooting in the operator's manual.
The system ID for this device within the network.
IP address for this unit within the network.
Displays the network synchronization log.
Displays various details regarding the TZT2BB unit, radar and fish finder.
3. EQUIPMENT SETUP
Options (setting range)
-180.0° to +180.0°
-50% to +50%
-180° to +180°
-10°C to +10 °C
Options (setting range)
0 to 59 (seconds)
Options (setting range)
[OFF], [ON]
0.0 (kn) to 98.9 (kn)
0.1 (kn) to 99.0 (kn)
10% to 50%
Option (setting range)
Option (setting range)
3-9