Furuno TZT2BB Installation Manual page 25

For unused cables
1) Cover the loose end of the cable connector with self-vulcanizing tape.
2) Wrap the connector with a layer of vulcanizing tape, covering
approx. 50 mm of the connected cable.
Note: Confirm that the connector is covered.
3) Wrap vinyl tape over the self-vulcanizing tape on the connector.
4) Wrap the connector with a layer of vinyl tape.
5) Bind the tape end with a cable tie to prevent the tape from unraveling.
Self-vulcanizing tape
50 mm
Self-vulcanizing tape
Vinyl tape
Cable tie
Vinyl tape
2. WIRING
2-3