Furuno TZT2BB Installation Manual page 31

2.8.1 How to connect the TZT2BB to NMEA 2000 equipment
Below is an example of two TZT2BB units, connected via NMEA 2000 to NMEA 2000
sensors.
Terminator
Note 1: When using a DC-DC converter to supply power to the NMEA2000 network
externally, use an isolated converter.
Note 2: The NMEA 2000 network requires a dedicated NMEA 2000 power supply.
Turn the NMEA 2000 network power on before turning your connected equipment on.
Note 3: Terminators must be installed at both ends of the NMEA 2000 backbone ca-
ble.
2.8.2 How to connect Yamaha engine(s)
When interfaced with Yamaha outboard engine(s) compatible with Command Link
Command Link Plus
on a dedicated Yamaha engine status display.
How to connect the engine
The NavNet TZtouch2 connects to the Yamaha engine network via the Yamaha Inter-
face Unit. Arrange the Yamaha Interface Unit through a local Yamaha representative.
The Yamaha Engine Hub (Yamaha supply), which connects between the engine and
the Yamaha Interface Unit, is also required.
TZT2BB
Ethernet connection
via HUB-101
NMEA 2000 backbone NMEA 2000 backbone
To ship-board power To ship-board power
®
and Helm Master
Yamaha Interface Unit
To Yamaha Engine Hub To Yamaha Engine Hub To Yamaha Engine Hub
(Command Link cable) (Command Link cable) (Command Link cable)
To NMEA 2000 Backbone To NMEA 2000 Backbone To NMEA 2000 Backbone
(Micro-C cable(Male)) (Micro-C cable(Male)) (Micro-C cable(Male))
TZT2BB
Terminator
T-connector T-connector
®
, the TZT2BB can display engine information
2. WIRING
®
,
2-9