How To Set Up The Radar - Furuno TZT2BB Installation Manual

3. EQUIPMENT SETUP
[Initial Setup] menu - [Engine & Tank Manual Setup]
The manual set up method should only be used if the automatic setup did not correctly
detect your engines or tanks.
TANK SENSOR
ENGINE SENSOR
Menu Item
[Instance]
[Data Source]
[Nickname]
[Fluid Type]
[Used For Propulsion]
[Reset]
3.4

How to Set Up the Radar

1. Tap the [FURUNO] icon (
settings.
2. Tap [Radar] from the [Settings] menu.
3. Tap [Radar Source], then select the appropriate radar sensor.
Note: If a DRS sensor is connected but does not appear in the [Radar Source] list,
close the list and open it again. The name of the DRS sensor should appear with
a check mark, as in the example below.
4. Drag the [Radar] menu display the menu item [Radar Initial Setup], then tap
[Radar Initial Setup].
5. Referring to the tables on the following pages, set up the radar.
3-12
Engine & Tank Setup
Instance Data Source NickName
Instance Data Source NickName
Description
Engine, tank NMEA 2000 instance number.
Engine, tank source.
Change the nickname for the engine or tank.
Engine, tank, fluid type.
Select which engine/tank is used to
calculate the distance which may be
traveled using the remaining fuel. [ON] uses
the engine/tank for calculations, [OFF] ig-
nores the engine/tank.
Resets the engine/tank details to default.
Reset
Fluid Type Used for Propulsion
Used for Propulsion
Options (setting range)
[OFF], [ON]
) to show the home screen and display mode