Furuno TZT2BB Installation Manual page 46

3. EQUIPMENT SETUP
Menu item
[Factory Reset]
[DATA ACQUISITION] menu
Menu Item
[GP330B WAAS Mode]
[WS200 WAAS Mode]
[Data Source]
[Sensor List]
[NMEA0183 Output]
Note: If the TTM sentence
is received at the same
time as another sentence,
the constraints to commu-
nication bandwidth may
cause a decrease in the
number of TTM targets.
[NMEA2000 PGN Output]
[Sky View]
[NMEA2000 Log] menu
Menu item
[Enable NMEA
2000 Log]
[NMEA2000 Log
Storage Location]
[SC-30 SETUP] menu
This menu is only available with SC-30 connection.
Menu item
[WAAS Mode]
[Heading Offset]
[Pitch Offset]
[Roll Offset]
[NETWORK SENSOR SETUP] menu
The [NETWORK SENSOR SETUP] section allows you to set up compatible FURUNO
NMEA 2000 sensors. Calibrations and offsets applied in this menu are also applied to
the sensor itself.
Tap the sensor to access its menus and settings. For details regarding the menu struc-
ture and set up of each sensor, see the appropriate operator's manual, supplied with
the sensor.
3-8
Description
Resets the converter selected at
[Select IF] to factory default.
Description
Select [ON] to use the WAAS mode for the
corresponding GPS antenna.
Select the source for each data to input to the system. If two or more
sources are connected for a data, select one using the pull-down dialog
box. The FURUNO products are shown at the upper part of the list.
Show the information for sensors connected to your equipment. Also,
you can set "Nickname" for them here.
[Port Configuration] - [Baud Rate]: Select
the output baud rate.
[Port Configuration] - [NMEA-0183 Ver-
sion]: Select the NMEA 0183 version for
output.
[Sentences]: Select the sentences to out-
put.
Select [ON] for the PGN's (Parameter Group Number, NMEA 2000
message) to output from the NMEA 2000 port.
Note: The default setting of some PGN's is "ON".
Show the condition of GPS and GEO (WAAS) satellites. Number, bear-
ing and elevation angle of all GPS and GEO satellites (if applicable) in
view of your GPS receiver appear.
Description
Enable or disable saving of NMEA 2000 data.
Select where to save NMEA 2000 data.
Description
Select [ON] to use the WAAS mode.
Enter the offset value for heading.
Enter the offset value for pitching.
Enter the offset value for rolling.
Options (setting range)
[OK], [Cancel]
Options (setting range)
[OFF], [ON]
[4,800], [9,600], [38,400]
[1.5], [2.0], [3.0]
[OFF], [ON]
Options (setting range)
[OFF], [ON]
Options (setting range)
[OFF], [ON]
-180° to +180°
-90° to +90°
-90° to +90°