H3C VSR Series Command Reference Manual page 36

Field
Description
Maximum Transmit Unit
Physical: InLoopBack
Last 300 seconds input: 0 bytes/sec,
0 bits/sec, 0 packets/sec
Last 300 seconds output: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
# Display brief information about interface Inloopback 0.
<Sysname> display interface inloopback 0 brief
Brief information on interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
InLoop0
Table 8 Command output
Field
Brief information on interface(s)
under route mode:
Link: ADM - administratively down;
Stby - standby
Protocol: (s) - spoofing
Description
UP(spoofing). UP(spoofing) means that the data link layer protocol state
of the interface is up, but the link is an on-demand link or is not present.
Description string of the interface, which is always InLoopBack0
Interface and cannot be configured.
MTU of the interface, which is always 1536 and cannot be configured
The physical type of the interface is inloopback.
Average input rate during the last 300 seconds (displayed when the
interface supports traffic statistics collection):
•
bytes/sec—Average number of bytes received per second.
•
bits/sec—Average number of bits received per second.
•
packets/sec—Average number of packets received per second.
Average output rate over the last 300 seconds (displayed when the
interface supports traffic statistics collection):
•
bytes/sec—Average number of bytes sent per second.
•
bits/sec—Average number of bits sent per second.
•
packets/sec—Average number of packets sent per second.
Total number and size (in bytes) of incoming packets of the interface
and the number of dropped packets (displayed when the interface
supports traffic statistics collection).
Total number and size (in bytes) of outgoing packets of the interface
and the number of dropped packets (displayed when the interface
supports traffic statistics collection).
Link Protocol Main IP
UP UP(s) --
Description
Brief information about the inloopback interface.
Explains the Link field values:
•
ADM—The interface has been shut down by the network
administrator. To recover its physical layer state, run the undo
shutdown command.
•
Stby—The interface is a standby interface. To view the primary
interface information, run the display interface-backup state
command.
Explains the Protocol field value.
(s) represents spoofing. If the data link layer protocol of an interface is up,
but its link is an on-demand link or is not present, the Protocol field
31
Description