Table of Contents
Advertisement
Field
Bandwidth
Maximum Transmit Unit
Internet Address is 192.168.1.200/24
Primary
IP Packet Frame Type
Hardware address
IPv6 Packet Frame Type
flow-control
Last link flapping
Last clearing of counters
Last 300 seconds input: 0 packets/sec 0
bytes/sec 0%
Last 300 seconds output: 0 packets/sec
0 bytes/sec 0%
Input(total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0
multicasts, 0 pauses
Input(normal): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0
multicasts, 0 pauses
input errors
Description
•
UP—The interface is up at the data link layer.
•
UP (spoofing)—The data link layer protocol of the interface is
UP. However, its link is an on-demand link or not present. This
attribute is typical of Null interfaces and loopback interfaces.
•
DOWN—The data link layer protocol of the interface is down.
Expected bandwidth of the interface.
MTU of the interface.
Primary IP address of the interface.
Ethernet framing format. PKTFMT_ETHNT_2 indicates that the
frames are encapsulated in Ethernet II framing format.
MAC address of the interface.
IPv6 packet framing format.
Generic flow control status of the interface.
The amount of time that has elapsed since the most recent physical
state change of the interface. This field displays Never if the
interface has been physically down since device startup.
Time when the reset counters interface command was last used to
clear the interface statistics. This field displays Never if the reset
counters interface command has never been used on the interface
since device startup.
Average inbound or outbound traffic rate (in pps and Bps) in the last
300 seconds, and the ratio of the actual rate to the interface
bandwidth.
The two fields on the first line represent the inbound traffic statistics
(in packets and bytes) for the interface. All inbound normal packets,
abnormal packets, and normal pause frames were counted.
The four fields on the second line represent:
•
Number of inbound unicast packets.
•
Number of inbound broadcasts.
•
Number of inbound multicasts.
•
Number of inbound pause frames.
A hyphen (-) indicates that the statistical item is not supported.
The two fields on the first line represent the inbound normal traffic
and pause frame statistics (in packets and bytes) for the interface.
The four fields on the second line represent:
•
Number of inbound normal unicast packets.
•
Number of inbound normal broadcasts.
•
Number of inbound normal multicasts.
•
Number of inbound normal pause frames.
A hyphen (-) indicates that the statistical item is not supported.
Statistics of incoming error packets.
16
Advertisement
Table of Contents
