H3C VSR Series Command Reference Manual page 9

The execution failed on a member interface in interface range view and succeeded in system
view.
The command is not executed on the subsequent member interfaces.
You can use the display this command to verify the configuration in interface view of each member
interface. In addition, if the configuration in system view is not needed, use the undo form of the
command to remove the configuration.
To verify the configuration of the first interface in the interface range, execute the display this command
in interface range view.
To view the member interfaces of an interface range, use the display interface range command.
When you bulk configure interfaces, follow these guidelines:
You cannot enter the view of some interfaces by using the interface interface-type
•
{ interface-number | interface-number.subnumber } command. Do not configure any of these
interfaces as the first interface in the interface range.
• Do not assign both an aggregate interface and any of its member interfaces to an interface range.
Some commands, after being executed on both an aggregate interface and its member interfaces,
can break up the aggregation.
No limit is set on the maximum number of interfaces in an interface range. The more interfaces in
•
an interface range, the longer the command execution time.
The maximum number of interface range names is limited only by the system resources. To
•
guarantee bulk interface configuration performance, H3C recommends that you configure fewer
than 1000 interface range names.
Examples
# Add GigabitEthernet 1/0 and GigabitEthernet 2/0 to the interface range named myEthPort, and
enter the interface range view.
<Sysname> system-view
[Sysname] interface range name myEthPort interface gigabitethernet 1/0 gigabitethernet
2/0
[Sysname-if-range-myEthPort]
# Enter the view of the interface range named myEthPort.
<Sysname> system-view
[Sysname] interface range name myEthPort
[Sysname-if-range-myEthPort]
Related commands
display interface range
4