Displaying Unit Identity - Paradyne 3172 Operator's Manual

ACCULINK 317x E1 DSU/CSU

Displaying Unit Identity

The identity of the E1 DSU/CSU (serial number, model
number, software revision level, hardware revision level,
and customer identification) is available through the
Status branch of the front panel menu (see Appendix A,
Front Panel Menu).
The customer identification is the only identity number
you can change.
To display the E1 DSU/CSU's identity (ID),
1. Press F1 to select Status from the top-level menu
screen.
DSU E1 CEPT
Stat
F1
2. Press the key three times on the Status screen
to bring the ID selection onto the front panel LCD.
Status:
DevHS STest
F1
3. Press F3 to select ID from the Status screen.
Status:
TStat
F1
4. The following screens appear in the order listed
each time you press the
Identity:
Ser=xxxxxxx
F1
3-8
Test Cnfig
F3
F2
Perf
F3
F2
LED ID
F2 F3
key.
F2 F3
March 1996
Identity:
Mod=xxxx-xx-xxx
F1 F2
NOTE
The third-from-last digit in the
model number may vary due to
the type of power supply shipped
with the E1 DSU/CSU. Refer to
the label on the bottom of the E1
DSU/CSU for the correct model
number.
Identity:
Cust ID=xxxxxxxx
F1 F2
Identity:
SRev=xx.xx.xx
F1 F2
Identity:
CCA1=xxxx-xxx
F1 F2
Identity:
CCA2=xxxx-xxx
F1 F2
F3
F3
F3
F3
F3
3170-A2-GB20-10