Displaying Led Conditions - Paradyne 3172 Operator's Manual

ACCULINK 317x E1 DSU/CSU

Displaying LED Conditions

The same conditions monitored by the front panel
LEDs can also be monitored by the LED command. This
command is most useful when the E1 DSU/CSU is being
accessed remotely (see Appendix G, Front Panel
Emulation). When using Front Panel Emulation, no LEDs
are shown on the PC's screen; you must use the Stat
command procedure described below to get LED
information.
To display LED conditions on the front panel screen,
1. Press F1 to select Stat from the top-level menu
screen.
DSU E1 CEPT
Stat
F1
2. From the Status screen, press the
display the LED selection.
Status:
DevHS STest
F1
3. Select LED from the Status screen.
Status:
Perf
F1
3-10
Test Cnfig
F3
F2
key to
Perf
F2 F3
TStat LED
F3
F2
March 1996
4. From the Select LEDs screen, press the Function
key that corresponds to E1 or the port for which
you want to display LEDs. Use the scroll keys, if
necessary.
Select LEDs:
E1 Prt1
F1 F2
If you chose E1, the LED Display screen lists the
LED signals, two at a time, on the second line. A
vertical bar at the left of the LED name indicates
the condition is ON, while an underscore indicates
the condition is Off.
LED Display:
_Test _NetSig
F1 F2
If you chose a port, the Port n LEDs screen lists
the LED signals, two at a time, on the second line.
A vertical bar at the left of the LED name
indicates the condition is ON, while an underscore
indicates the condition is Off.
Port n LEDs:
_DTR _TXD
F1 F2
5. Use the and keys to scroll LED names
onto the screen.
Prt2
F3
F3
F3
3170-A2-GB20-10