Set-Up Mode; Introduction; Entering Set-Up Mode - Pace PROGRAMMABLE THERMOFLO Operation & Maintenance Manual

SET-UP MODE

INTRODUCTION

In Set-Up Mode you can:
1. Install, remove or change a password.
2. Set the Temperature scale to °C or °F as desired.
3. Delete stored profiles.
Use the following procedure to enter the Set-Up mode and make any changes.

ENTERING SET-UP MODE

1. Set the Power Switch to the Off ("0") position.
2. Press and hold the ENTER key while switching the Power
Switch to the On ("1") position. The Digital Readout will now
display a version message and change to read Password
Needed ?
3. Release the ENTER key.
If a password is currently stored in memory, "Enter Password" will be
displayed. Enter the 4 key numerical password sequence to continue.
72
Figure 103.
Figure 104.
NOTE