Angle Bracket Kit - Pace PROGRAMMABLE THERMOFLO Operation & Maintenance Manual

ANGLE BRACKET KIT

The Angle Bracket Kit elevates the front of the power source to allow easier viewing and access to the front
panel controls. Attach the kit to the ThermoFlo power source using the following instructions. Also, if you have
purchased a PRC 1500 or PRC 1500E system, a second kit is included; attach the second kit to the PPS 85 (or
PPS 85E power source.
1. Turn the power source upside down on the work
bench with the front panel facing away from you.
2. Loosen the 2 Thumb Nuts shown in the illustration
and slide toward the rear of the power source.
The ThermoFlo Unit is shipped with the 2
Thumb Nuts and Mounting Screws
attached to the bottom of the power
source case. Power sources other than
the ThermoFlo will require installation of
the 2 Thumb Nuts and 2 Mounting Screws
onto the power source case.
3. Position Angle Bracket to the front of the power
source and just behind the two (2) rubber feet on
the power source case.
4. Slide the 2 mounting slots in the Angle Bracket
beneath the 2 Thumb Screws. You may need to
adjust the Thumb Nuts to provide enough space
between the Thumb Nuts and the power source
case.
5. Tighten Thumb Nuts to secure bracket in position.
6. Remove the paper backing from the two (2) rubber
feet and place in position on the Angle Bracket as
shown in the illustration.
NOTE
Figure 5.
SET-UP
11