Entering/Editing A Profile - Pace PROGRAMMABLE THERMOFLO Operation & Maintenance Manual

OPERATION

ENTERING/EDITING A PROFILE

The ThermoFlo unit allows the user to store user-defined profiles, including parameters for preheat, soak, reflow
and cool down. Any previously stored profiles can be changed quickly and easily using this procedure.
When entering a new profile, you can begin by using a similar previously stored profile. Make the appropriate
changes and store the new profile under a new profile storage number. See step 2.
When editing (changing) a profile previously stored in memory, you must recall the program you wish to change,
then edit the profile. See step 2.
Use the following procedure to enter a profile into system memory or to change a stored profile.
The illustrations used in the following procedure display messages with all
temperature references shown in °C, components as "PLCC" and numerical
values as "X" (user defined). The 1/YES and 3/NO Keys are described
simply as YES and NO for clarity of instruction.
The unit may display a message of "Enter Password" if a password has
been stored in memory. Enter the 4 key password sequence when this
message is displayed.
1. Press and release the MODE Key until the PROGRAM Mode Light
illuminates.
The procedure may be exited at any time using the MODE/ESC Key. If any
changes have been made to the profile being edited, the Digital Readout
will display a message asking if you wish to save these changes.
Ultimately, "Exit Edit Mode ?" will be displayed. Press the YES Key to exit
the editing procedure.
58
NOTE
NOTE
Figure 71.