Quick Start; Introduction; Manual Mode Of Operation - Pace PROGRAMMABLE THERMOFLO Operation & Maintenance Manual

QUICK START

INTRODUCTION

The PACE ThermoFlo unit is easy to operate and can be quickly set up for use in Manual and Timed modes of
operation. The following Manual and Timed Modes of Operation sections provide basic guidelines for rework
using the PACE ThermoFlo.
For complete instructions detailing these operations, read the Operation and Set-Up Mode sections of this
manual.

MANUAL MODE OF OPERATION

REMOVAL
1. Install proper Nozzle onto ThermoFlo Handpiece.
2. Turn Power Switch ON. Press MODE/ESC Key until Manual Mode
Light illuminates.
3. Adjust Set Temperature and Blower Speed as desired using Scroll Keys.
See
4. Lower Nozzle over component (slightly above component leads) to
direct air flow to solder joints. See
5. Press and hold handpiece Cycle Switch to initiate reflow cycle.
6. When complete reflow of solder joints is observed, lift component from
PCB using PACE HandiPik or tweezers.
16
Figure 10.