Quickfit Nozzle Adapter; Optional Accessories - Pace PROGRAMMABLE THERMOFLO Operation & Maintenance Manual

SET-UP

QUICKFIT NOZZLE ADAPTER

The ThermoFlo QuickFit Adapter allows you to easily change out any PACE ThermoFlo Nozzle. Attach the
adapter to the handpiece heater using the following instructions.
1. Insert the QuickFit Adapter into the end of the
handpiece heater as shown.
2. Position the QuickFit Adapter so the Line on the heater
is aligned with one of the 3 lines (1 long & 2 short
lines) on the Locking Collar. Tighten Collar Locking
Screw to secure adapter in position.

OPTIONAL ACCESSORIES

Install all purchased options (e.g., work platform, lights, camera system) at this time. A separate installation/
instruction manual (PACE part number 5050-0421) is enclosed with these options.
14
Figure 8.