Table of Contents
Advertisement
PRECAUTIONS
The following are general safety precautions which personnel must understand and follow when using or
servicing this product. These precautions may or may not be included elsewhere in this manual.
USEAGE PRECAUTIONS
CAUTIONS
1. The ThermoFlo handpiece heater assembly housing and any installed nozzle are hot when the system
is being cycled and for a period of time thereafter. DO NOT touch either the heater assembly
housing, nozzle or direct heated air stream. Severe burns may result!
2. Always use the handpiece with the Heat Shield installed except when the handpiece is mounted to its
work platform. The Heat Shield helps to prevent unintentional contact with the heater.
3. Utilize all standard electrical safety precautions when using this or any other electrical equipment.
4. Always use this system in a well-ventilated area. A fume extraction system such as those available
from PACE are highly recommended to protect personnel from solder flux fumes.
5. Exercise proper precautions when using chemicals (e.g., solder paste). Refer to the Material Safety
Data Sheet (MSDS) supplied with each chemical and adhere to all safety precautions recommended by
the manufacturer.
SERVICING PRECAUTIONS
DANGERS
POTENTIAL SHOCK HAZARD - Repair procedures performed on this product should be
performed by qualified service personnel only. Line voltage parts will be exposed when equipment is
disassembled. Service personnel must avoid contact with these parts when troubleshooting.
NOTES
To insure continued peak performance, use genuine PACE replacement parts.
SAFETY
9
Advertisement
Table of Contents
