Thermoflo Cubby Kit; Hose Retention Kit - Pace PROGRAMMABLE THERMOFLO Operation & Maintenance Manual

SET-UP

THERMOFLO CUBBY KIT

The ThermoFlo Cubby Kit can be attached to either side of the power source.
To attach the ThermoFlo Cubby Kit (handpiece holder) to the power source, use the following instructions.
1. Position the Holder as shown with the curved wire
ends directly beneath the mounting holes in the
Cubby Bracket. Secure the Holder to the bracket
using the two (2) Holder Mounting Screws, Washers
and Locknuts.
2. From the rear of the power source, insert the 2
enclosed Bracket Mounting Screws (head first) into
top "T" Slot on the side of the power source case.
Pull the screws toward the front of the power
source.
3. Place the Cubby onto the side of the power source,
inserting the two (2) Mounting Screws through any
two (2) opposing Mounting Holes in the Cubby
Bracket. The multiple mounting holes allow the
user to adjust the Cubby as desired.
4. Install a Thumb Nut onto the end of each Mounting
Screw.
5. Adjust Cubby Bracket flush with front of power
source. Tighten Thumb Nuts to secure bracket in
position.

HOSE RETENTION KIT

The ThermoFlo Hose Retention Kit can be attached to either side of the power source. Attach the Hose
Retention Kit to the power source using the following instructions.
1. Attach the Slide Tube to the Retention Bracket as shown using the Tube Mounting Screw and
Lockwasher. Position tube with Tube Access Hole facing in direction shown. Tighten the Tube
Mounting Screw to secure in position.
12
Figure 6.