Table of Contents
Advertisement
OPERATION
MANUAL COMPONENT INSTALLATION
1. Install the proper Nozzle and Vacuum Cup (if not using Single Jet nozzle) onto the handpiece.
2. Set the unit POWER Switch (on rear panel of power source) to the ON
position.
3. Press and release MODE/ESC Key as necessary until the MANUAL Mode
Light is illuminated.
4. Adjust the Set Temp as desired using the Temperature Scroll Up and Down
keys. Press and hold the key; observe the Digital Readout as the Set
Temperature increases (or decreases) in 1° and then 10° increments as the key
is held.
5. Adjust the Blower Speed (1-9) as desired using the Blower Speed Scroll Up
and Down keys.
36
Figure 30.
Figure 31.
Figure 32.
Advertisement
Table of Contents
