Timed Component Installation - Pace PROGRAMMABLE THERMOFLO Operation & Maintenance Manual

OPERATION
TIMED MODE COMPONENT INSTALLATION
The ThermoFlo System Work Platform (PACE part number 6018-0099) is
optionally available to assist in the installation/removal process.
1. Install the proper Nozzle Assembly and Vacuum Cup (if not using Single Jet nozzle) onto the
handpiece.
2. Set the unit POWER Switch (on rear panel of power source) to the ON position.
3. Press and release MODE/ESC Key as necessary until the TIMED Mode INSTALL
Light is illuminated.
4. Adjust the Set Temp as desired using the Temperature Scroll Up and
Down keys. Press and hold the key; observe the Digital Readout as the
Set Temperature increases (or decreases) in 1° and then 10° increments
as the key is held.
5. Adjust the Blower Speed (1-9) as desired using the Blower Speed
Scroll Up and Down keys.
6. Adjust the Cycle Time as desired using the Cycle Time Scroll Up and
Down keys. Press and hold the key; observe the Digital Readout as the
Set Temperature increase (or decrease) in 1 second and then 10 second
increments as the key is held.
44
NOTE
Figure 47.