Manual Mode Of Operation; Manual Component Removal - Pace PROGRAMMABLE THERMOFLO Operation & Maintenance Manual

MANUAL MODE OF OPERATION

MANUAL MODE COMPONENT REMOVAL
1. Install the proper Nozzle Assembly and Vacuum Cup onto the handpiece. Ensure that the PCB
assembly to be reworked and any replacement component have been properly prepared.
Any required preheating operating should be completed before advancing
beyond this point.
2. Set unit POWER Switch (on power source rear panel) to the ON position.
3. Press and release MODE/ESC Key as necessary until the MANUAL Mode Light is
illuminated.
4. Adjust the Set Temp as desired using the Temperature Scroll Up and Down keys.
Press and hold the key; observe the Digital Readout as the Set Temperature
increases (or decreases) in 1° and then 10° increments as the key is held.
5. Adjust the Blower Speed (1-9) as desired using the Blower Speed Scroll Up and
Down keys.
NOTE
OPERATION
Figure 23.
Figure 24.
Figure 25.
33