Using Your Data On The Srev1 - Yamaha S Rev1 Supplementary Manual

Using Your Data on the SREV1

Using Your Data on the SREV1
Put your data in the right folder
1
The SREV1 can only load impulse-response data stored in the "c:\yamaha\srev\data"
folder of the PC Card. So the first thing you need to do is to make a new folder called
"data" in "x:\yamaha\srev\" and copy your acquired data into it, something you can do
on your PC. (Note that "x" refers to the letter assigned to your PC Card while it's
inserted in your PC.)
Insert the PC card into the SREV1
2
Insert the PC Card into the SREV1's MEMORY CARD slot.
Load your data
3
On the RC-SREV1, go to the Rev page, select the DATA LOAD button, and press
[ENTER] to access the Data Load page. Next, select the PCMCIA button and press the
[ENTER] button. Your impulse-response data should appear in the list of files.
Use the DATA wheel or the [-1/DEC] and [+1/INC] buttons to select your file in the
list. And then select the button of the channel to which you want to load the data. Click
the [ENTER] button to load the data. Repeat this procedure to load data for the other
channels.
Audition your reverb data
4
Now you can listen to the reverb generated from your own samples.
Adjust the EQ
5
On the Data Load page, select the BACK button and press the [ENTER] button to
return to the Rev page. Go to the EQ pages and try adjusting the pre- and post-EQ
parameters.
Save your program
6
If you're happy with your new reverb program, go to the Program page and save it to
PC Card now!
10
SREV1 Sampling Guide