Rear Panel - Yamaha CDR1000 Owner's Manual

Rear Panel

AC IN
1 2
A
Cooling fan
The cooling fan keeps the internal components cool. See "Installation" on page 2 for
more information.
B
AC IN connector
This connector is used to connect the CDR1000 to an AC outlet, using the supplied
power cord. See "Connecting the Power Cord" on page 19 for more information.
C
ANALOG OUT connectors
These balanced male XLR-3-32 type
connectors output analog playback and
monitor signals. They are wired pin
1–ground, pin 2–hot (+), and pin
3–cold (–).
D
ANALOG IN connectors
These balanced female XLR-3-31 type
connectors are used to connect analog
input signals. They are wired pin
1–ground, pin 2–hot (+), and pin
3–cold (–). See "Selecting the Input
Source" on page 33 for more informa-
tion.
If you need to connect the balanced ANALOG IN or ANALOG OUT to unbalanced
equipment, using phone or phono connectors, link XLR pins 1 and 3, as shown in the
following illustration for an unbalanced phone-plug to female XLR cable.
Tip (hot)
Sleeve (ground)
E
ANALOG IN level switch
This switch is used to set the input sensitivity of the ANALOG IN connectors to either
+4 dB or –10 dBV.
ANALOG OUT ANALOG IN
R L R L
3 4
1/4" phone plug
PARALLEL DIGITAL(COAXIAL)
OUT
–10dBV +4dB
5 6 7 8
Male XLR connector
Female XLR connector
Female XLR plug
13

Rear Panel

DIGITAL(AES/EBU)
WORD
OUT IN
CLOCK
IN
IN
9 J K
1 (ground)
3 (cold)
2 (hot)
2 (hot)
3 (cold)
1 (ground)
2 (hot)
3 (cold)
1 (ground)
CDR1000—Owner's Manual