UDO AUDIO SUPER 6 Owner's Manual page 95

NAVIGATION
IMPORTANT SAFETY
INSTRUCTIONS
ACKNOWLEDGEMENTS
INTRODUCTION
OVERVIEW
QUICK START
UPDATING THE FIRMWARE
CONNECTIONS
SOUND DESIGN &
PROGRAMMING
EFFECTS
PERFORMANCE CONTROL
SECTION (KEYBOARD
MODEL)
ADDITIONAL CONTROLS &
PARAMETERS (DESKTOP
MODEL)
USING THE MODULATION
MATRIX
VOICE ASSIGN
ARPEGGIATOR &
SEQUENCER
GLOBAL SETTINGS
MPE SUPPORT
FILE MANAGEMENT
HOW-TO GUIDE
CHEAT SHEET
MIDI SPECIFICATIONS
GLOSSARY
SUPPORT INFORMATION
• BUTTON 3: MIDI Note Output. When enabled (LED lit), the arpeggiator
and sequencer will output MIDI notes during playback. Please note
that Local Control needs to be enabled for this option.
• BUTTON 4: MIDI Stop Message Receive. When enabled (LED lit), each
of the two HOLD buttons "arms" the sequencer while the latter waits
for a MIDI start message to start playback. In this mode, the sequencer
will stop playback when a MIDI Stop message is received, even if the
external MIDI clock is still running.
When this option is disabled (LED flashing), each of the two HOLD
buttons will start and stop the sequencer asynchronously. A MIDI Start
message will "snap" the sequence back into the correct timing, but
a MIDI Stop message will be ignored if the external MIDI clock is still
running.
In both modes, transport control is achieved via Note On/Off
messages. This gives you easy control over when a sequence should
start or stop, and also allows you to transpose a sequence.
To exit the external clock settings, press SHIFT again.
Please note that you can either enable option 1 or option 2. As
soon as you enable one of these options, the other is automatically
disabled.
If you enable MIDI Clock Receive, the arpeggiator or sequencer
won't respond until a MIDI clock signal is received.
The Super 6 automatically switches to MIDI Clock Receive when
it detects an external MIDI clock signal. You can manually disable
this setting after a MIDI clock signal was detected, or choose not to
send MIDI clock signals from an external sequencer or a DAW to the
Super 6 to enable arpeggiator or sequencer playback regardless of
external clock signals.
UDO Super 6 — Owner's Manual 95