UDO AUDIO SUPER 6 Owner's Manual page 15

NAVIGATION
IMPORTANT SAFETY
INSTRUCTIONS
ACKNOWLEDGEMENTS
INTRODUCTION
OVERVIEW
QUICK START
UPDATING THE FIRMWARE
CONNECTIONS
SOUND DESIGN &
PROGRAMMING
EFFECTS
PERFORMANCE CONTROL
SECTION (KEYBOARD
MODEL)
ADDITIONAL CONTROLS &
PARAMETERS (DESKTOP
MODEL)
USING THE MODULATION
MATRIX
VOICE ASSIGN
ARPEGGIATOR &
SEQUENCER
GLOBAL SETTINGS
MPE SUPPORT
FILE MANAGEMENT
HOW-TO GUIDE
CHEAT SHEET
MIDI SPECIFICATIONS
GLOSSARY
SUPPORT INFORMATION
Setting up Your Super 6
Follow the steps below to setup your brand-new synthesizer:
1. Plug the power cable into the power connector on the rear panel of
the Super 6.
2. Use unbalanced 1/4-inch audio cables to connect the outputs
labelled OUTPUT L/R to your mixer or audio interface, or connect
headphones to the headphone output on the rear panel.
3. Turn on the Super 6.
4. Set the MASTER VOLUME control to about 0 dB.
5. Play some notes or chords and adjust the levels on your mixer or
audio interface.
See pages 24-27 for a full overview of the Super 6's connections.
UDO Super 6 — Owner's Manual 15