UDO AUDIO SUPER 6 Owner's Manual page 103

NAVIGATION
IMPORTANT SAFETY
INSTRUCTIONS
ACKNOWLEDGEMENTS
INTRODUCTION
OVERVIEW
QUICK START
UPDATING THE FIRMWARE
CONNECTIONS
SOUND DESIGN &
PROGRAMMING
EFFECTS
PERFORMANCE CONTROL
SECTION (KEYBOARD
MODEL)
ADDITIONAL CONTROLS &
PARAMETERS (DESKTOP
MODEL)
USING THE MODULATION
MATRIX
VOICE ASSIGN
ARPEGGIATOR &
SEQUENCER
GLOBAL SETTINGS
MPE SUPPORT
FILE MANAGEMENT
HOW-TO GUIDE
CHEAT SHEET
MIDI SPECIFICATIONS
GLOSSARY
SUPPORT INFORMATION
TX/RX E: Press this button to determine how parameter changes are sent
and received via MIDI. You can combine the following options:
• BUTTON 1: MIDI CC Transmit. When enabled (LED lit), parameter
changes are transmitted as continuous controller messages.
• BUTTON 2: MIDI CC Receive. When enabled (LED lit), parameter
changes are received as continuous controller messages.
• BUTTON 3: NRPN mode. When enabled (LED lit), parameter changes
are transmitted as unregistered parameter number messages at a
resolution of 14 bits if MIDI CC Transmit is also enabled.
To exit this parameter, press TX/RX E again.
When MIDI CC Receive is enabled, the Super 6 will always respond
to both parameter changes sent in 7 and 14 bit resolution.
TX/RX P: Press this button to determine whether program change
messages should be transmitted and received via MIDI. You can combine
the following options:
• BUTTON 1: When enabled (LED lit), program change messages are
transmitted.
• BUTTON 2: When enabled (LED lit), program change messages are
received.
To exit this parameter, press TX/RX P again.
DUMP: Reserved for future use.
LOCAL: This button toggles Local Control on or off. Disabling Local
Control can be useful if you want to control external MIDI devices or avoid
MIDI data loops while recording in a DAW.
• ON: When Local Control is on (LED lit), the Super 6's front panel
controls and keyboard are connected to the internal sound engine.
• OFF: When Local Control is off (LED not lit), the Super 6's front panel
controls and keyboard have no effect on its sound engine.
With Local Control disabled and MIDI CC Transmit and Receive
enabled, MIDI data is still transmitted through the MIDI outputs.
UDO Super 6 — Owner's Manual 103