UDO AUDIO SUPER 6 Owner's Manual page 17

NAVIGATION
IMPORTANT SAFETY
INSTRUCTIONS
ACKNOWLEDGEMENTS
INTRODUCTION
OVERVIEW
QUICK START
UPDATING THE FIRMWARE
CONNECTIONS
SOUND DESIGN &
PROGRAMMING
EFFECTS
PERFORMANCE CONTROL
SECTION (KEYBOARD
MODEL)
ADDITIONAL CONTROLS &
PARAMETERS (DESKTOP
MODEL)
USING THE MODULATION
MATRIX
VOICE ASSIGN
ARPEGGIATOR &
SEQUENCER
GLOBAL SETTINGS
MPE SUPPORT
FILE MANAGEMENT
HOW-TO GUIDE
CHEAT SHEET
MIDI SPECIFICATIONS
GLOSSARY
SUPPORT INFORMATION
In the second example, patch 8 from bank D1 is loaded:
To load a different patch from the same bank:
• Press one of the seven numbered buttons (1-8) that are currently
unlit. Its LED will then light up.
If the LED of one of the select buttons does not light up, this
indicates that the corresponding memory location is empty.
To load a patch from a different first bank:
1. Press one of the seven lettered buttons (A-H) that are currently unlit.
Its LED will light up, indicating that one of the first banks (A1-H1)
has been selected.
2. Press one of the numbered buttons (1-8). Its LED will then light up.
Changing the bank does not load a new patch. A new patch is
loaded only by pressing one of the numbered buttons after a bank
has been selected.
To load a patch from a second bank:
1. Press either the currently lit lettered button again or one of the other
lettered buttons (A-H) twice. Its LED will start flashing, indicating
that one of the second banks (A2-H2) has been selected.
2. Press one of the numbered buttons (1-8). Its LED will then light up.
After loading a patch from one of the second banks (A2-H2), you
remain in select mode for those banks until you load a patch from
one of the first banks (A1-H1) and vice versa.
UDO Super 6 — Owner's Manual 17