UDO AUDIO SUPER 6 Owner's Manual page 59

NAVIGATION
IMPORTANT SAFETY
INSTRUCTIONS
ACKNOWLEDGEMENTS
INTRODUCTION
OVERVIEW
QUICK START
UPDATING THE FIRMWARE
CONNECTIONS
SOUND DESIGN &
PROGRAMMING
EFFECTS
PERFORMANCE CONTROL
SECTION (KEYBOARD
MODEL)
ADDITIONAL CONTROLS &
PARAMETERS (DESKTOP
MODEL)
USING THE MODULATION
MATRIX
VOICE ASSIGN
ARPEGGIATOR &
SEQUENCER
GLOBAL SETTINGS
MPE SUPPORT
FILE MANAGEMENT
HOW-TO GUIDE
CHEAT SHEET
MIDI SPECIFICATIONS
GLOSSARY
SUPPORT INFORMATION
• HF TRK: Selecting this option enables high-frequency mode with key
tracking. In this mode, LFO 1 can be used either as a third oscillator or
as a dynamic modulation source for audio rate modulation. The tuning
of LFO 1 can be matched to that of DDS 1 and DDS 2 with the RATE
fader. By default, LFO 1 is set to a sine wave in this mode.
To extend LFO 1's capabilities, you can employ a cunning trick and
make use of the Super 6's 'Battwave' modification. This allows you
to use the waveform that DDS 1 is currently set to (including the
alternative DDS 1 waveforms) as LFO 1's waveform. Note that this
doesn't include DDS 1's noise waveform.
Press the SHIFT button and at the same time, move LFO 1's
rotary control one position in any direction. The waveform, copied
from DDS 1, will be used either in the high frequency modes or
in low frequency mode depending on whether the position you
move the rotary control one position to, is a high frequency mode
or low frequency mode. Switching the rotary switch once more,
without holding SHIFT, will resume normal operation of LFO with
its standard waveforms. This method offers you a broad palette of
alternate oscillator flavours to use as LFO 1's waveform. Deluxe.
The MODE toggle switch allows you to choose between three types of
LFO behaviours:
• FREE: With this setting, LFO 1 is free-running.
• ONCE: With this setting, LFO1 only goes through one duty cycle when
you play a note. In this mode, LFO 1 can also be used as a simple
envelope whose shape is determined by the selected waveform.
• RESET: With this setting, the phase of LFO 1 will be reset each time
you play a note.
When LFO 1 is set to one of the two high-frequency modes, you can use
the MODE toggle switch to select one of the following modes:
• NORM: With this setting, LFO 1 acts as a modulation source in high-
frequency mode.
• DDS 1: With this setting, the audio signal from LFO 1 in high-frequency
mode is routed to the channel of DDS 1. The output signals from LFO 1
and DDS 1 are summed, so you can crossfade between this summed
signal and the audio signal from DDS 2 in the mixer section.
• DDS 2: With this setting, the audio signal from LFO 1 in high-frequency
mode is routed to the channel of DDS 2. The output signals from LFO 1
and DDS 2 are summed, so you can crossfade between this summed
signal and the audio signal from DDS 1 in the mixer section.
UDO Super 6 — Owner's Manual 59