UDO AUDIO SUPER 6 Owner's Manual page 72

NAVIGATION
IMPORTANT SAFETY
INSTRUCTIONS
ACKNOWLEDGEMENTS
INTRODUCTION
OVERVIEW
QUICK START
UPDATING THE FIRMWARE
CONNECTIONS
SOUND DESIGN &
PROGRAMMING
EFFECTS
PERFORMANCE CONTROL
SECTION (KEYBOARD
MODEL)
ADDITIONAL CONTROLS &
PARAMETERS (DESKTOP
MODEL)
USING THE MODULATION
MATRIX
VOICE ASSIGN
ARPEGGIATOR &
SEQUENCER
GLOBAL SETTINGS
MPE SUPPORT
FILE MANAGEMENT
HOW-TO GUIDE
CHEAT SHEET
MIDI SPECIFICATIONS
GLOSSARY
SUPPORT INFORMATION
The LFO 2 trigger and destination controls.
The leftmost toggle switch determines how LFO 2 is triggered:
• TRIG: With this setting, pushing the bender upwards will trigger LFO 2.
• AT + TRIG: With this setting, both aftertouch and pushing the bender
upwards will trigger LFO 2. If you use the bender and apply pressure
to a key at the same time, only the gesture with the greater effect on
triggering LFO 2 will control the modulation depth.
• ON (AT -> BEND): With this setting, LFO 2 is permanently on.
Additionally, aftertouch is now set to trigger the same modulations
controlled by horizontal bender movements.
VCF: This fader controls the amount by which LFO 2 modulates the low-
pass filter's cutoff frequency.
DDS: This fader controls the amount by which LFO 2 modulates the pitch
of the oscillators.
The oscillator selector toggle switch determines which oscillator is
affected by the pitch modulation controlled by LFO 2. You have the choice
between three options:
• DDS 1: With this setting, only the pitch of the first oscillator will be
affected by LFO 2.
• 1 + 2: With this setting, the pitch of both oscillators will be affected by
LFO 2.
• DDS 2: With this setting, only the pitch of the second oscillator will be
affected by LFO 2.
UDO Super 6 — Owner's Manual 72