UDO AUDIO SUPER 6 Owner's Manual page 104

NAVIGATION
IMPORTANT SAFETY
INSTRUCTIONS
ACKNOWLEDGEMENTS
INTRODUCTION
OVERVIEW
QUICK START
UPDATING THE FIRMWARE
CONNECTIONS
SOUND DESIGN &
PROGRAMMING
EFFECTS
PERFORMANCE CONTROL
SECTION (KEYBOARD
MODEL)
ADDITIONAL CONTROLS &
PARAMETERS (DESKTOP
MODEL)
USING THE MODULATION
MATRIX
VOICE ASSIGN
ARPEGGIATOR &
SEQUENCER
GLOBAL SETTINGS
MPE SUPPORT
FILE MANAGEMENT
HOW-TO GUIDE
CHEAT SHEET
MIDI SPECIFICATIONS
GLOSSARY
SUPPORT INFORMATION
TUNE: Press this button to auto-tune the Super 6's filters for calibration
purposes. The LEDs of Buttons 1-8 and A-H will indicate the progress of
the auto-tune process from left to right until 12 LEDs are lit. As soon as the
filter calibration is complete, the LEDs will turn off.
MPE: Press this button to enter the Super 6's MIDI Polyphonic Expression
(MPE) settings. See pages 105-106 for more details. You can combine the
following options:
• BUTTON 1: When enabled (LED lit), the Super 6 will respond to
incoming MIDI messages sent from an MPE controller.
• BUTTON 2: When enabled (LED lit), a dead zone for polyphonic
aftertouch is active, which defines a starting value from which
polyphonic aftertouch affects the sound. This allows you to play a
note without immediately triggering polyphonic aftertouch on MPE
controllers that don't provide a dead zone setting for this purpose.
Enabling this option is recommended for use with ROLI controllers or
the Osmose.
• BUTTON 3: When enabled (LED lit), the Y-axis sensitivity (assigned
to CC74) is reduced. This essentially limits the modulation scope
controlled by front/back movements in case this gestural dimension
turns out to be too sensitive in relation to the fully available modulation
range. Enabling this option is recommended for use with the
LinnStrument or the Osmose.
To exit this parameter, press MPE again.
MPE settings are stored per patch, allowing you to customise each
patch to your MPE controller.
TRNSP (Desktop model only): Press this button to adjust the global
transpose setting. Once you press the TRNSP button, you can use
the MOD AMOUNT encoder to transpose the pitch globally by +/- 12
semitones. The current transpose setting is indicated by the LEDs of
buttons 1-8 and A-H. When no transposition was applied, no LED is
flashing. As you transpose up, the LEDs of buttons A-H start flashing. As
you transpose down, the LEDs of buttons 1-8 start flashing.
GLOBAL RESET: If your Super 6 is not behaving as expected, you can
reset the global parameters to their default settings:
1. Turn on the Super 6.
2. Press and hold the MANUAL button for 5 seconds until all LEDs
turn on and off again.
3. The auto-tune process starts automatically. Release the MANUAL
button and wait for the auto-tune process to complete.
UDO Super 6 — Owner's Manual 104